Initiating The Customer Receipt Test (Test/Status Receipt) - Toshiba TCx 2tn Quick Installation Manual

Dual station printer

Hide thumbs

Table Of Contents

Table of Contents

Print a Test/Status receipt to verify that the setup was successful and to identify other

network information

Note: Network settings (such as the IP address and Hostname) are printed on the Test/

Status Receipt. This information might be required to complete solution setup and view

connection status. See Firmware offline tests and the Test/Status Receipt for additional

information.

Using the TCx Printer Configuration Utility

To use the TCx Printer Configuration Utility, complete the following steps.

Run the TCx Printer Configuration Utility from a network attached system, such as a

computer or POS system.

Select the network Device menu (available printers will be listed by IP address). You might

need to refresh the list to show a new printer, or in some cases you might need to enter the

IP address.

Select the printer to be set up and enter the required parameters.

Save the configuration and restart the printer to use the new settings.

Print a Test/Status receipt to verify the setup was successful, and to determine important

network information.

Note: The network settings (such as the Network name, IP address, and Hostname), which

might be required to complete the solution setup, are printed on the Test/Status Receipt. See

Firmware offline tests and the Test/Status Receipt for additional information.

Using the web interface

To use the web interface, complete the following steps.

Using a network attached system such as a computer or POS system, open a browser to the

printer IP address printed on the Test/Status receipt that was previously printed.

Open the Ethernet page and enter the required parameters.

Save the configuration and restart the printer to use the new settings.

Print a Test/Status receipt to verify that the setup was successful and to identify other

important network information.