Table of Contents
Advertisement
Error code
191 PSD Error
192 PSD Error
193 PSD Error
194 PSD Error
195 PSD Error
199 Service Reflash RIP
5060-XXX
Action
EOS sensor out of range process direction (Yellow) - Replace the
Yellow
"PSD Sensor Assembly" on page
Note: It is necessary to remove the Printhead Assembly to access
the PSD Sensor Assembly, therefore it is necessary to perform the
"Printhead Adjustments" on page
No EOS reading (Black) - Go to
page
2-96.
Note: It is necessary to remove the Printhead Assembly to access
the PSD Sensor Assembly, therefore it is necessary to perform the
"Printhead Adjustments" on page
No EOS reading (Cyan) - Go to
page
2-96.
Note: It is necessary to remove the Printhead Assembly to access
the PSD Sensor Assembly, therefore it is necessary to perform the
"Printhead Adjustments" on page
No EOS reading (Magenta) - Go to
page
2-96.
Note: It is necessary to remove the Printhead Assembly to access
the PSD Sensor Assembly, therefore it is necessary to perform the
"Printhead Adjustments" on page
No EOS reading (Yellow) - Replace the Yellow
Assembly" on page
4-35.
Note: It is necessary to remove the Printhead Assembly to access
the PSD Sensor Assembly, therefore it is necessary to perform the
"Printhead Adjustments" on page
This message indicates that the printer has detected an invalid
version of the RIP code and must be reflashed to the approved
version. Contact your next level support.
4-35.
4-1.
"PSD Service Check" on
4-1.
"PSD Service Check" on
4-1.
"PSD Service Check" on
4-1.
"PSD Sensor
4-1.
Diagnostic Information
2-17
Advertisement
Table of Contents
