Table of Contents
Advertisement
User Primary
Message
Insert Staple Cartridge
Load Staples
5060-XXX
User Secondary Message
Explanation
This message will be displayed when the staple
cartridge is missing or installed incorrectly. This
message can be displayed at any of the following
times, regardless of the Staple Alarm setting.
* At POST
* After the Stapler Door has been closed.
The following actions can be taken when this
message is displayed:
* Install the staple cartridge
or
* Press Go to ignore this message.
The printer will now handle staple jobs as if the
staple unit were installed with no staples. The
"Staples Empty" warning will appear on the status
line and "Load Staples" may immediately appear.
This message will be displayed when the Staples
Empty Alarm is activated and one of the following
has occurred:
* There are no staples in the staple unit or the
staple unit is not installed.
This message may be displayed at any of the
following times:
* Prior to printing the first page of a batch of
pages that are to be stapled or during the printing
of a batch of pages that are to be stapled (if the
condition cannot be detected prior to printing the
first page of the batch).
The following actions can be taken while this
message is displayed:
* A new staple cartridge may be installed to clear
this message and start/continue printing the
staple batch
or
* Ignore the Load Staples request for this print job
by pressing Go or Select.
The printer will resume printing, however the print
job for which stapling was selected will not be
stapled or press Menu> or Menu< to access the
Busy/Waiting Menu Group.
The following functions will be available via the
Busy/Waiting Menu:
* Cancel Job
* Reset Printer
* Reset Active Bin
* Check Supply Levels
Note: Menu Lockout does NOT prevent access to
the Busy/Waiting Menu Group.
Diagnostic Information
2-33
Advertisement
Table of Contents
