Error Code Table - Toshiba e-STUDIO 20CP Service Manual

Error Code Table

Error code
900 RIP Software
902 Service Engine Error 0
904 Engine Software
905 Engine Software
906 Engine Software
907 Engine Software
908 Engine Software
910 Trans Sensor
911 Trans Sensor
912 Trans Sensor
913 Trans Sensor
914 Trans Sensor
915 Trans Sensor
916 Trans Sensor
2-6
Service Manual
5060-XXX
Action
Contact your next level support.
General Engine Software Errors 902 through 908 indicate an
unrecoverable engine software error. The Engine Board may cause
this type of error. Turn the printer off and on to try and clear the
error code. If this does not fix the problem after several attempts,
call your next level support before replacing the Engine Board.
Interface violation by RIP - Check all cabling and connections to
the RIP board. If no problem is found, replace the
page 4-10.
Interface violation by Paper Port Device - Turn the printer off and
on to try and clear the error code. If this does not fix the problem
after several attempts, do the following:
Check each paper handling option to isolate which one is causing
the problem. If you do not find a problem with any of the options,
replace the "Engine Board" on page
Engine RAM Error - Replace the
Engine Flash Error - The Engine Board might be causing the error
code. Try the following:
Reflash the Engine Board with the correct level code. If this does
not fix the problem, replace the
Engine ASIC Error - Replace the
Tray 1 Transparency Sensor Error - Replace Tray 1 Transparency
Sensor Assembly. If this does not fix the problem, replace the
"Engine Board" on page
Tray 2 Transparency Sensor Error - Replace Tray 2 Transparency
Sensor Assembly. If this does not fix the problem, replace the
"Engine Board" on page
Tray 3 Transparency Sensor Error - Replace Tray 3 Transparency
Sensor Assembly. If this does not fix the problem, replace the
"Engine Board" on page
Tray 4 Transparency Sensor Error - Replace Tray 4 Transparency
Sensor Assembly. If this does not fix the problem, replace the
"Engine Board" on page
Tray 1 Transparency Sensor Error - Replace Tray 1 Transparency
Sensor Assembly. If this does not fix the problem, replace the
"Engine Board" on page
Tray 2 Transparency Sensor Error - Replace Tray 2 Transparency
Sensor Assembly. If this does not fix the problem, replace the
"Engine Board" on page
Tray 3 Transparency Sensor Error - Replace Tray 3 Transparency
Sensor Assembly. If this does not fix the problem, replace the
"Engine Board" on page
"RIP Board" on
4-14.
"Engine Board" on page
"Engine Board" on page
"Engine Board" on page
4-14.
4-14.
4-14.
4-14.
4-14.
4-14.
4-14.
4-14.
4-14.
4-14.