Table of Contents
Advertisement
User Primary
Message
Change <input
source> <Custom
String>
Change <input
source> <Size>
Change <input
source> <type> <size>
Reattach Output Bin x
Reattach Bins x-y
Check Tray x
Connection
Check Duplex
Connection Check
Finisher Connection
Close Door
Close Finisher Door
5060-XXX
User Secondary Message
Explanation
One of the following will be displayed on line two.
* The user can define a name for each of the
custom types (Custom 1 thru 6)
These messages will be displayed anytime the
printer loses communications with one of the
following options:
* Output Bin x(x=1,2 or 3)
* Bins (x-y=1 thru 5)
* Tray x (x=2,3,4 or 5)
* Duplex
* Finisher
This message may be displayed in two ways. The
specified option could have been removed form
the printer, maybe to clear a paper jam or to
uninstall the option or the option may be still
installed but experiencing a communications
problem such as not being fully installed or has a
hardware failure. The most likely cause of this
message is a failure to reattach the option when
removed to service a printer intervention. The
following actions can be taken while this
message is displayed. If the option was
temporarily removed or not connected properly,
then reattach or reconnect it. When the option is
recognized, the printer will automatically clear the
attendance message and continue. Press GO to
execute a configuration change which will tell the
printer the option has been Hot Uplugged
removed. In this case it is assumed that the user
wishes to continue to operate the printer with the
option removed. If the problem continues, turn
the printer off and back on. If the message
continues to be displayed, turn the printer off,
remove the option and call for service.
This message will be displayed when the printer
upper front cover (door) is open.
* Close the upper front cover (door)
This message will be displayed when the Finisher
Option top cover is open. Close the finisher top
cover.
Diagnostic Information
2-31
Advertisement
Table of Contents
