Table of Contents
Advertisement
User Primary
Message
38 Memory Full
39 Complex Page
51 Defective Flash
5060-XXX
User Secondary Message
Explanation
This message will be displayed when the printer
is processing an incoming job and there is not
enough memory available to continue processing
the job.
The following actions can be taken while this
message is displayed:
You may want to determine how to make more
memory available to your print job by:
* Deleting Fonts, macros and other data in RAM
* Simplify your print job
* Install additional Memory
* Press Go to clear the message, however some
data may be lost
* Press Menu> or Menu< to access the Busy/
Waiting Menu Group
The following functions may be available.
* Cancel Job
* Reset Printer
* Reset Active Bin
* Check Supply Levels
Note: Menu Lockout does NOT prevent access to
the Busy/Waiting Menu Group.
This message will be displayed when a page is
too complex to print.
The following actions can be taken while this
message is displayed:
* Press Go to clear the message and continue
processing the job, some data loss may occur.
* Try to simply the print job
Press Menu> or Menu< to access the Busy/
Waiting Menu Group.
The following functions may be available:
* Cancel Job
* Reset Printer
* Reset Active Bin
* Check Supply Levels
Note: Menu Lockout does NOT prevent access to
the Busy/Waiting Menu Group.
This message will be displayed when the printer
detects a defective flash.
The following actions can be taken while this
message is displayed:
* Press Go to clear the message
The flash will marked as bad and normal
operation will continue. No flash operation will be
allowed until the flash problem is resolved.
Diagnostic Information
2-39
Advertisement
Table of Contents
