Table of Contents
Advertisement
4.
Move the rear of the printhead to a position that allows the color of the printhead
being adjusted to align over the black target on the left side of the Alignment Test
Page. Tighten the right rear mounting screw (A).
5.
Run an Alignment Test Page to verify the printhead rear adjustment.
6.
Move the front of the printhead to a position that allows the printhead color to align
over the black target on the right side of the Alignment Test Page. Tighten the front
mounting screw.
7.
Run an Alignment Test Page to verify the printhead front adjustment.
Note: You may be required to make both front and rear printhead adjustments several
times to obtain correct manual alignment on both sides of the Alignment Test Page.
8.
After you obtain correct front and rear printhead adjustments, tighten the left rear
printhead mounting screw.
5060-XXX
4-3
Repair Information
Advertisement
Table of Contents
