Table of Contents
Advertisement
User Primary
Message
Calibrate <Tray x>
Load Paper
Tray x Not Calibrated
Change Cartridge
<Color> Invalid Refill
Change <custom Type
Name> <input source>
2-30
Service Manual
User Secondary Message
5060-XXX
Explanation
This message will be displayed when the user
has initiated a tray calibration procedure. <Tray
x> = Tray 1 thru 4, MPF, Envelope Feeder,
Manual Paper and Manual Envelope.
The following actions can be taken while this
message is displayed:
* Load paper into Tray x and press Go to initiate
the calibration.
* Press Menu> or Menu< to access the Busy/
Waiting Menu Group.
The following functions will be available via the
Busy/Waiting Menu:
* Reset Printer
* Reset Active Bin
* Check Supply Levels
This message will be displayed when a tray has
been detected that is uncalibrated. This message
usually means a user-correctable NVRAM
problem or the tray was not calibrated at the
factory or needs to be calibrated.
Perform the following steps to calibrate a tray:
1. Turn the printer off.
2. Press and hold the SELECT and RETURN buttons
while powering on the machine.
3. Release the buttons when Performing Self Test is
displayed.
4. Select Calibrate Trays from the menu.
5. Select Tray X from the menu.
6. The display will prompt load paper if necessary.
7. Load paper.
8. Press Go.
9. Calibrating Tray X will be displayed
10. Repeat for any other Trays that might need to be
calibrated.
11. Exit Configuration Menu.
This message will be displayed when the printer
has detected a refilled prebate cartridge. <Color>
can be one of the following:
*Black, CYAN, Magenta or Yellow.
The following actions can be taken while this
message is displayed.
* Remove the toner cartridge and install a new
cartridge.
Note: The user will receive this message for
every invalid cartridge installed.
This message will be displayed when the printer
is requesting the operator to change the media
installed in one of the input sources. <input
source>=Tray 1 thru 5, MPF or Envelope Feeder.
Advertisement
Table of Contents
