Table of Contents
Advertisement
Ready - Bin X Full displays and paper feeds into Bin X.
Step
Action and Questions
1
Bin X Sensor Flag - Check the Bin X sensor flag to make it
is not in the up position and is operating correctly.
Is the sensor flag operating correctly?
Paper does not feed into the bin selected. 271 Paper Jam - Check
Bin 1 displays.
Step
Action and Questions
1
Bin parts - Check all the bin parts, deflector, deflector
spring, deflector cover, deflector cover spring and shaft
assemblies for signs of missing or loose springs. Check for
binds in the deflector or deflector cover, broken or binding
shaft assemblies or broken gear teeth.
Are parts broken, loose, binding or missing?
2
Bin X Solenoid - Check the solenoid for any binds or
sticking problems.
Is the solenoid binding or sticking?
3
Bin X Solenoid - Check the resistance of the solenoid. It
measures between approximately 30 ohms and 50 ohms.
Is the resistance correct?
4
Mechanical Linkage/Motor Assembly - Check the gears,
clutch and other linkage parts for correct operation and any
signs of wear, broken gear teeth or damaged parts.
Are the mechanical linkage assembly mechanical parts
broken, worn or damaged?
990 Service Error Displays
Step
Action and Questions
1
Mechanical Linkage/DC Motor Assembly - Check the DC
motor cable connector to make sure it is installed at J4 on
the Control Board.
Is the cable connected correctly?
2-68
Service Manual
5060-XXX
Yes
Replace the
Bin X Sensor.
If this does not
fix the problem
replace the
Control Board.
Yes
Replace parts
or repairs
necessary
Replace the
Solenoid
Assembly
Replace the 5
Bin Mailbox
Control Board
Assembly
Replace the
Mechanical
Linkage/DC
Motor
Assembly
Yes
Go to Step 2
No
Repair or
replace as
necessary
No
Go to Step 2
Go to Step 3
Replace Bin X
Solenoid
Assembly
Replace the 5
Bin Mailbox
Control Board
Assembly
No
Reseat the
cable and
recheck for
correct
operation of
the option
Advertisement
Table of Contents
