Table of Contents
Advertisement
Customer
Receipt
Paper Cover
Customer Receipt Feed Button
Document Feed Button
Customer Receipt
Printer Station
2. Check the status of the Printer Ready LED:
3. If the POST fails or if you suspect problems with your terminal, see "Problem
4. See "Offline tests" and run the offline tests. If the offline tests fail or you suspect
Offline tests
The following offline tests are used as diagnostic tools to ensure the printer is
operating correctly.
Customer receipt test
1. Press and hold both the customer receipt feed button and the document feed
2. Press and release the customer receipt feed button to start this test.
3. See Figure 3-1 on page 3-4 and verify that your printer has printed correct
3-2
4610 SureMark Three– Station Printer: User's Guide
Document Present LED
Printer Ready LED
Printer ready LED ON:
The POST completed successfully.
Printer ready LED OFF or blinking:
The POST failed.
determination" on page 3-7.
problems with your terminal, see "Problem determination" on page 3-7.
button to enter offline mode. When the printer ready indicator begins blinking,
release both buttons.
information for your model and configuration:
v MICR reader enabled and check flipper enabled for a model TN4 and Gx4
printer.
v RS-232, RS-485, or USB serial interface
v Applicable parameters for RS-232 communications (models TNx only):
– 9600 or 19,200 baud rate
– DTR/DSR or XON/XOFF control
v A solid line should appear as the last line of the test pattern
If any characters that appear in Figure 3-1 on page 3-4 are missing from the
test pattern you print, or if the solid line is missing, go to "Problem
determination" on page 3-7.
Journal paper
cover
Journal Printer Station
Journal Feed Button
Document Insert
Ribbon Cover
Document Insert
Printer Station
Advertisement
Table of Contents
