Table of Contents
Advertisement
75 23064
75 23 067
33-
26.0
Rear wheel drive
- installing
Coat
input
bevel pinion splines with Staburags NBU 30
PTM or Optimoly Paste PL.
Fit rear wheel drive on rear swinging arm and secure with
four retaining
screws.
Tightening torque:
Rear wheel drive retaining screws
40 ±
3
Nm
Push
spring
strut
over mounting
pin.
Fit washer and hex nut.
Tighten spring strut retaining screws
attop and bottom.
Tightening torque:
Spring strut mounting
at
top and bottom
51 ±3Nm
Models with
rear drum brake
Introduce pull rod through brake backplate. Screw on
wing nut.
Turn rear wheel,
screwing
in pull rod wing nut until the
rear
wheel
is just braked. Then slacken the wing nutthrough
3-4 revolutions (equivalentto app.
25
mm footbrake pedal
play)
.
Models with
rear disc brake
Fit brake caliper on brake disco
Screw on retaining
screws
with
a
was her behind and
mounting bracket in front,
and
tighten
.
Tightening
torque:
Brake caliper retaining screws
32±2Nm
8.87
Advertisement
Table of Contents
