Steering Head Tube - Installing - BMW K75 Repair Manual

Steering head tube - installing
When installing:
Punch mark (arrow) must be located between the clamp
halves when assembled.
Tighten retaining screws for clamps.
Tightening torque:
Retaining screw . . . . . . . . . . . . . .. 22 ± 2 Nm
Adjust steering head bearing, remove tape red screws for Fluidbloc.
1 ••• 1
(K75cfrom FrameNo.O 113805)
Eliminate all play at adjustment ring, tighten locking tube and hex nut.
1 • • • • 1
andK75cuptoFrameNo.0 113 804
Eliminate all play at round nut, tighten stop screw.
Tighten clamping screws attop and then at boltom .
Tightening torques:
Stopscrew . . . . . . . . . . . . . .
Locking tube and hex nut(5 mm deep) .
Locking tube and hex nut (7 mm deep) .
Clamping screws, top . .
Clamping screw, boltom . . . . . . . .
Note:
When off-load, the telescopic fork mustfall evenly to the
lett or right from the cEl!1tre position .
Ensure that the wire cables and electric cables are located
properly.
1 ---1
Tighten tapered screws again.
Tightening torque:
Tapered screws . . . . . . . . . . . . . . . . 9 ± 1 Nm
Push distributor pipe up through steering head tube.
When installing:
When installing, note the lug atthe base of the distributor
pipe and on the groove in the fork bridge.
1 • • • 1
(K75cfrom FrameNo.O 113 805)
Fit clampto distributor pipe with a suitable pipe (spring
lugs point upwards).
1 • • • • 1
andK75cuptoFrameNo;0 113804
Secure distributor pipe with plastic nut (smooth side
downwards).
Tightening torque:
Plasticnut . . . . . . . . . . , . . . • . . . 10 ± 1 Nm
8.87
.74±5Nm
.45 ± 3Nm
. 65 ± 5Nm
.21 ±1 Nm
.43±3 Nm
75 31023
31-27.0