Table of Contents
Advertisement
7534015
34-12.0
Front brake pads
-
removing and installing
Carefully lift off the protective cap with
a
screwdriver.
Using a suitable drift, force out
retaining
pins (1) and (2),
working from the wheel side.
Take out the spring
and
pin.
Pull outthe brake pads, using
a
wire
hook
if necessary.
To preventscore marks on the brake disc, the brake pads
must be renewed in good time
if
the minimum thickness is
reached (see picture) .
.
When
instalfing:
'
Before the new brake pads are inserted, push back the
piston into the brake cylinder.
Ensure thatthe spring and pin
are
properly located.
Drive
in
retaining pins with an arbor until they engage in
position.
Front brake caliper- removing
and
installing
Drain the brake system.
Unscrew the brake pipe (1) on brake caliper.
Remove the retaining screws (arrow) and take off the
brake
caliper.
When assembling, work in the opposite sequence.
Fill and bleed the brake system
as
when changing brake
fluid.
Tightening torques:
Retaining screw
Brake pipe to brake caliper
Bleedscrew
32±2Nm
7±1Nm
7±1Nm
8.87
Advertisement
Table of Contents
