BMW K75 Repair Manual page 45

All 2v models
Hide thumbs Also See for K75:
Table of Contents

Advertisement

Carefully
lever
off the
brake
caliper cap. Drive out
retaining
pins
(1) and (2) from the side facing the wheel
(arrows) with an arbor.
Take outthe spring and clamping pins.
Pull outthe brake pads (e.g
.
with wire
hook).
Insert the piston setting-back device, BMW
34 1 500,
in
the brake caliper and push back the piston
into
the brake
caliper with an adjusting screw.
Only in this way is it possible to change the brake fluid
behind the piston.
Take out the piston setting-back device and substitute
with
spacer,
BMW
34 1
510,
to holdthe piston back
in
the
brake caliper.
On twin disc brakes,
insert
the piston setting-back device
in the second caliper and push back the piston.
Setthe lever on the bleeding device to
"
Compressed-air
operated"
.
Connect up the line from the overflow tank to
the brake caliper bleed screw (arrow), open the bleed
screw with an open-ended wrench and allow all the brake
fluid
to
drain out (perform this procedure at both brake
calipers).
8.87
7534013
75
34014
00
-
47.0

Advertisement

Table of Contents
loading

This manual is also suitable for:

K100 lt

Table of Contents