Increased Starting Speed Cable - Removing And Installing - BMW K75 Repair Manual

Install cable connector in front right corner offrame triangle.
Setthrottle cable play to 1 mm at adjuster on right handlebar fitting . Push rubber sleeve over adjuster.
Note:
The throttle butterfly switch must be heard to click when the twistgrip is turned slightly.
Install the impact pad .
Install the fuel tank.
r • • • • r
K 1 00 RS, RT, L T: install the lower leftfairing section and the knee pads on left and right.
Increased starting speed cable- removing and installing
r • • • r
Remove fuel tank (see Group 16).
Remove impact pad .
r • • • • r
K 1 00 RS , RT, L T: remove knee pads on left and right (see Group 46).
Removefuel tank (see Group 16).
Remove impact pad .
Disconnect wire cable on handlebar:
Lever off plastic cap on actuator lever with a screwdriver
and remove the slotted screw (arrow).
Lift off the actuator lever and lift out the cable (arrow) .
8 .87
32 - 13.0