Throttle Cable - Removing - BMW K75 Repair Manual

When installing:
Punch mark (arrow)must be located between the clamp
halves when assembled.
Tighten retaining screws for clamps.
Tightening torque:
Retaining screw
Throttle cable - removing
,
...
,
Remove fuel tank (see Group 16).
Remove impact pad .
re ••• ,
22±2Nm
531023
K 1 00 RS, RT, L T: remove knee pads on left and right and remove lower left fairing (see Group 46). Remove fuel tank
(see Group 16). Remove impact pad.
Turn carn disc inwards inthe direction ofthe arrow.
Disconnectthe cable .
Liftthe cable out ofthe reaction bearing .
Remove the coverfrom the throttle operating mechanism.
Using actuating carn (1), pull the chain through until the
cable can be disconnected atthe end ofthe chain (arrow) .
Pull the chain out ofthe handlebarfitting.
8.87
..... 32 - 11 .0