Table of Contents
Advertisement
Insert retaining screws (arrow) and tighten.
Tightening torque:
Retaining screws
Bottom
section
of crankcase
-
installing
7±1Nm
The crankcase sealing faces must be free of oil and
grease. Apply a thin coatofthree Bond 1207 B tothe
sealing faces.
Insert the O-rings for oil and water passages.
Offer
up
the bottom
section
of the crankcase and
alternately
tighten the retaining screws (1 and 2).
Tightening torque:
Retaining screw (1)
Retaining screw (2)
40±
5Nm
18
± 2Nm
Install the oil strainer. Secure the pipe (arrow) with O-ring
in the rubber bushing on the bottom section ofthe
crankcase.
Wetthe seal althe oil filter with oil.
Note:
Screw in the oil filter as far as the stop and then tighten
further by max. 1/2 turn
.
Tightening
torque:
Retaining screws
7±1Nm
Oil sump
-
installing
The sealing faces on the
crankcase
bottom section must
be free of oil and
grease.
Apply a thin coat ofThree Bond
1207 B to the sealing faces. Offer up the oil sump.
Uniformly tighten the oil sump retaining screws (arrows).
Install the drain screw with
a
new sealing ring.
Tightening torque:
Retaining
screws
7
±
1 Nm
Drain screw
32 ± 4
Nm
8.87
24911
063
11-77.0
Advertisement
Table of Contents
