Front Brake Discs - Removing And Installing - BMW K75 Repair Manual

Front brake discs - removing and installing
Raise the motorcyc1e with BMW hoist
00 1 510
until the
front wheel is free .
Remove retaining screws (arrows), pull brake caliper off
brake disc and allow to hang freely.
Slacken off c1amping screws (arrows) on quick-release
axle on either side.
Remove retaining screw (1) for quick-release axle.
Pull out quick-release axle, noting spacer (2) .
Pull front wheel forward to remove .
Remove four retaining screws for brake dises; take off
brake dises.
Assemble following the same procedure but in the reverse
order.
Tightening torques:
Brake disc to front wheel
Retaining screw for quick-release axle
Clamping screw for quick-release axle
Brake caliper to sliding tube
8.87
29±3Nm
33±4Nm
14±2Nm
32 ± 2Nm
34-17.0