BMW K75 Repair Manual page 82

~
__________________________ 24911019
11-32.0
Lower the lifting fixture so that the centre stand stands
upright.
Note:
The engine and gearbox must be atthe same heightto
avoid damaging the clutch release rod.
Pull the gearbox with complete driveline away totthe rear.
r • • • r
and
r • • • • r
Push BMWframe support 46 5 620 on tothe rearframe
tubes (arrows) and secure itwith pin (1).
Det~ch
the remaining frame mountings at the front left
and right ofthe engine and also atthe right ofthe
intermediate flange.
Note:
Note the shims.
Lift off the frame complete with telescopic fork and place it
on the workshop floor.
Detach the hose clip (1) at the air collector.
Open the retaining clips (arrows) forthe air cleaner
housing and separate the following plug connections:
temperature sensor, injector nozzles and throttle butterfly
switch .
Separate the cable connector at the injector rail and take
off the top section of the ai r cleaner housing with the
engine wiring harness.
B.B7