Table of Contents
Advertisement
Driveline
-
assembling
Position the assembly stand with engine at the hoist.
Raise the hoist until the engine litter can be
attached
to the
oilsump.
Slacken off the
engine
mount on the engine.
Connectthe complete driveline to the engine.
Note:
Coat the drive splines with Staburags.
It
is vital
that
the
engine
and gearbox
are
at the
same
height (to avoid damaging the clutch
thrust
rod)
.
Screw in the gearbox and engine retaining bolts.
Install and secure the starter motor.
Tightening torque:
Starter
on gearbox
7±1Nm
Mounting tor centre stand
-
removing and
installing
Slacken offthe retaining
screws
(arrow) forthe mounting
on the underside
of
the gearbox
and
take off
the
mounting.
Insert
and tighten the two
lower
gearbox and engine
retaining bolts.
Insert and
tigliten the
microencapsulated screws
in
the
underside of the gearbox to
secure
the mounting.
Tightening torque:
Gearbox to
engine
Mounting
to
gearbox
8.87
16
±2Nm
41
±
5Nm
11-89.0
Advertisement
Table of Contents
