Throttle Butterfly Assembly - Removing And Installing - BMW K75 Repair Manual

13 - 10.0
Throttle butterfly assembly - removing and installing
K100RS,RT,LT:
Remove knee pads (see Group 46).
Removefuel tank (see page 16- 07.0).
Remove lower fairings (see Group 46).
Pull intake tube off lower section of air cleaner housing
and intake pipe.
Unscrew intake pipe on radiator.
Loosen hose connectors on air line at collector (1) at the
air cleaner end (7 mm across flats) and pull offthe air line.
Take outthe upper section of the air cleaner housing.
Note:
The picture was taken with the engine removed to provide
a better illustration.
K100,K75,c,s:
Pull intake tube off lower section of air cleaner housing
and intake pipe.
K 1 00: unscrew intake pipe on radiator.
Removefuel tank (see page 16- 07.0).
Loosen hose connectors on air li ne at collector (1) at the
top (see illustration) and pull offthe air line.
Take out the upper section ofthe air cleaner housing.
K100RS,RT,LT:
After releasing the cable connector, push the divider
through the gap between the frame and air collector.
Dismantle the engine housing breather on the air
collector. Release the one-way hose connectors (arrows)
on throttle butterfly stub pipe with BMW pliers 13 1 500 ,
remove and take out the air collector.
8 .87