Handlebar; Steering Head Bearing - Adjusting - BMW K75 Repair Manual

1 • • • • 1
Push on upperfork bridge.
Screw in clamping screws (arrows).
When installing:
Fixed tubes must lie flush with the upper fork bridge .
Screwon the stop screw (1).
1 • • • 1
Push on the upperfork bridge, screw in the clamping
screws (arrows) and fitthe hex nut (1).
When installing:
Fixed tu bes must lie flush with the upper fork bridge.
Handlebar
When installing:
'!
The centre-punch mark (arrow) must lie between the two
clamping block halves when assembled.
Tighten clamping block retaining screws.
Tightening torque:
Retaining screw . . . . . • . . . • . . . .. 22 ± 2 Nm
Steering head bearing - adjusting
1 • • • • 1
Tighten stop screw (arrow).
Tighten the clamping screws first at the top, then at the
base.
Tightening torques:
Stopscrew . . . .
Upper clamping screw .
Lower clamping screw .
B.B7
74±5Nm
21 ±2Nm
43±3Nm
7531023
46-69.0