Table of Contents
Advertisement
Headlight
setting - adjusting
After any work affecting the headlight, check
its
adjustment.
If
no suitable beam aligning device
is
available, this work
can be carried out as folIows .
•
Checktyre pressures and correct
if
necessary.
•
Setthe suspension for solo
riding
The motorcycle should stand on its wheels, with the rider's weight on the dualseat, on a flat,
level
surface 5
metres
from
a light-coloured wall.
Measure Ihe dislance lrom Ihe Iloorio Ihe cenlre
ofthe
headlight. Mark Ihis dislance
on
Ihe wall wilh a cross, and make
another cross 5 cm below the first. Switch on the
low
(dipped) headlight beam and align the
headlight
so that the
light-
dark boundary
01
the beam runs to the left of the lower cross, rises to the height of the upper cross
to
the right of
the
centreline, then falls away again.
1
H
~j---
63
-
04.0
24963016
K 75 headlight
-
adjusting
Slacken off headlight retaining screws (arrows). Adjust
headlight according to diagram above.
K 75 c,
K
1 00 headlight
-
adjusting
Adjustthe headlight according to the diagram above at
the knurled
screw
by the left-hand telescopic fork fixed
tube.
Turned in direction
(1)
(anticlockwise) = beamthrow
shorter
Turned in direction (2) (clockwise)
=
beam throw
longer
B.B7
Advertisement
Table of Contents
