Table of Contents
Advertisement
Transport
Start Port and End Port Enter the port or ports used by the port forwarding service. To
IP Address
Translation Port
Forward all
unspecified ports to
5. Click
Ok
to return to the NAT screen. Within the NAT screen, click
changes made on the Port Forwarding screen.
6. Click
Cancel
to undo any changes made on Port Forwarding screen. This reverts all settings
for the Port Forwarding screen to the last saved configuration.
5.2.2 Configuring Dynamic DNS
The access point supports the Dynamic DNS service. Dynamic DNS (or DynDNS) is a feature offered
by www.dyndns.com which allows the mapping of domain names to dynamically assigned IP
addresses via the WAN port. When the dynamically assigned IP address of a client changes, the new
IP address is sent to the DynDNS service and traffic for the specified domain(s) is routed to the new
IP address.
NOTE DynDNS supports only the primary WAN IP address.
Use the
Transport
pull-down menu to specify the transport
protocol used in this service. The choices are ALL, TCP, UDP, ICMP,
AH, ESP, and GRE.
specify a single port, enter the port number in the
To specify a range of ports, use both the
options to enter the port numbers. For example, enter 110 in the
Start Port field and 115 in the End Port field.
numerical (non DNS name)
Enter the
specified service is forwarded. This address must be within the
specified NAT range for the associated WAN IP address.
Specify the port number used to translate data for the service being
forwarded.
Use the
Forward all unspecified ports to
port forwarding for incoming packets with unspecified ports. In the
adjacent area, enter a target forwarding IP address for incoming
packets. This number must be within the specified NAT range for
the associated WAN IP address.
Network Management
Start Port
area.
Start Port
and
End Port
IP address to which the
checkbox to enable
Apply
to save any
5-25
Advertisement
Table of Contents
