Chapter 2 Configuring The Ap; Gaining Access To The Ui; Using Telnet - Symbol Spectrum24 AP-3020 Reference Manual

Configuring the AP
Chapter 2
Software configuration requires setting up a connection to the AP and
gaining access to the UI (User Interface).
The dot in front of certain parameters, functions or options (
Primary Only
(ESS) when choosing the
2.1

Gaining Access to the UI

Setting up access to the UI depends on the connection used. Select the setup
that best fits the network environment. If using a PPP connection, access the
UI through a Telnet session.
2.1.1

Using Telnet

Using a Telnet session to gain access to the UI requires a remote station to
have a TCP/IP stack. The remote station can be on the wired or wireless LAN.
To access the AP from the workstation:
1. From the DOS prompt Telnet to the AP using its IP address:
2. At the prompt enter the password:
The password is case-sensitive.
Spectrum24 Access Point AP-3020 Product Reference Guide
) indicates these items are updated to all APs with the same Net_ID
Telnet xxx.xxx.xxx.xxx
Symbol
option.
Save ALL APs-[F2]
.Antenna Selection
35