Symbol AP-51xx Product Reference Manual page 97

Restore Default
Configuration
Restore Partial
Default Configuration
4. Use the Restart access point field to restart the AP (if necessary).
Restart AP-51xx
CAUTION After a reboot, static route entries disappear from the AP Route Table
!
if a LAN Interface is set to DHCP Client. The entries can be retrieved
(once the reboot is done) by performing an Apply operation from the
WEB UI or a save operation from the CLI.
5. Click Apply to save any changes to the System Settings screen. Navigating away from the
screen without clicking the Apply button results in all changes to the screen being lost.
NOTE The
configuration or restarting the access point.
6. Click Undo Changes
settings displayed on the System Settings screen to the last saved configuration.
Select the Restore Default Configuration
AP's configuration to factory default settings. If selected, a
message displays warning the user the current configuration will
be lost if the default configuration is restored. Before using this
feature, Symbol recommends using the
screen to export the current configuration for safekeeping, see
Importing/Exporting Configurations on page
Select the Restore Partial Default Configuration
restore a default configuration with the exception of the current
LAN, WAN, SNMP settings and IP address used to launch the
browser. If selected, a message displays warning the user all
current configuration settings will be lost with the exception of
WAN and SNMP settings. Before using this feature, Symbol
recommends using the
current configuration for safekeeping, see
Configurations on page
access point
Click the Restart
access point
the resets all data collection values to zero. Symbol
does not recommend restarting the AP during significant system
uptime or data collection activities.
Apply button is not needed for restoring the access point default
(if necessary) to undo any changes made. Undo Changes reverts the
button to reset the
Config Import/Export
4-41.
Config Import/Export screen to export the
Importing/Exporting
4-41.
button to reboot the AP. Restarting
4-5
System Configuration
button to