Table of Contents
Advertisement
7-36
AP-51xx Access Point Product Reference Guide
5. Click the
access point's. The recipient access point must be the same single or dual-radio model as
the access point sending the configuration. The sending and recipient access point's must
also be running the same major firmware version (i.e., 1.1 to 1.1).
CAUTION When using the Send Cfg to APs function to migrate an access point's
!
6. Click the
Start Flash
within the Known AP Statistics screen.
Use the
Start Flash
Known AP Statistics screen. When an access point is highlighted and the Start Flash button
is selected, the LEDs on the selected access point flash. When the
selected, the LEDs on the selected access point go back to normal operation.
7. Click the
prompt displays confirming the logout before the applet is closed.
Send Cfg to APs
button to send the your access point's configuration to other
configuration to other access points, it is important to keep in mind
mesh network configuration parameters do not get completely sent to
other access points. The Send Cfg to APs function will not send the
"auto-select" and "preferred list" settings. Additionally, LAN1 and
LAN2 IP mode settings will only be sent if the sender's AP mode is
DHCP or BOOTP. The WAN's IP mode will only be sent if the sender's IP
mode is DHCP.
button to flash the LEDs of other access points detected and displayed
button to determine the location of the devices displayed within the
Logout
button to securely exit the access point Symbol Access Point applet. A
Stop Flash
button is
Advertisement
Table of Contents
