Table of Contents
Advertisement
5-52
AP-51xx Access Point Product Reference Guide
2. Enable the radio(s) using the
Refer to
RF Band of Operation
or 802.11b/g radio. After the settings are applied within this Radio Configuration screen, the
Radio Status
network, these values update in real-time.
CAUTION If a radio is disabled, be careful not to accidentally configure a new
!
3. Select the
connections from other access points in client bridge mode. The base bridge is the acceptor
of mesh network data from those client bridges within the mesh network and never the
initiator.
4. If the Base Bridge checkbox has been selected, use the
to define the client bridge load on a particular base bridge.
Enable
parameter to ensure you are enabling the correct 802.11a
and
MUs connected
WLAN, expecting the radio to be operating when you have forgotten it
was disabled.
Base Bridge
checkbox to allow the access point radio to accept client bridge
checkbox(es).
values update. If this is an existing radio within a mesh
Max# Client Bridges
parameter
Advertisement
Table of Contents
