Symbol AP-51xx Product Reference Manual page 148

5-4 AP-51xx Access Point Product Reference Guide
5. Use the Port Settings
LAN port.
Auto Negotiation
100 Mbps
10 Mbps
half duplex
full duplex
6. Click Apply
the screen without clicking the Apply button results in all changes to the screen being lost
if the prompts are ignored.
7. Click Undo Changes
settings displayed on the LAN configuration screen to the last saved configuration.
8. Click Logout
displays confirming the logout before the applet is closed.
field to define how the access point manages throughput over the
Auto Negotiation
Select the
point to automatically exchange information (over its LAN port)
about data transmission speed and duplex capabilities.
Auto negotiation is helpful when using the access point in an
environment where different devices are connected and
disconnected on a regular basis.
Selecting Auto Negotiate disables the Mbps and duplex checkbox
options.
Select this option to establish a 100 Mbps data transfer rate for the
selected half duplex or full duplex transmission over the access
point's LAN port. This option is not available if Auto Negotiation is
selected.
Select this option to establish a 10 Mbps data transfer rate for the
selected half duplex or full duplex transmission over the access
point's LAN port. This option is not available if Auto Negotiation is
selected.
Select this option to transmit data to and from the access point, but
not at the same time. Using a half duplex transmission, the access
point can send data over its LAN port then immediately receive
data from the same direction in which the data was transmitted.
Like a full-duplex transmission, a half-duplex transmission can
carry data in both directions, just not at the same time.
Select this option to transmit data to and from the access point at
the same time. Using full duplex, the access point can send data
over its LAN port while receiving data as well.
to save any changes to the LAN Configuration screen. Navigating away from
(if necessary) to undo any changes made. Undo Changes reverts the
to securely exit the access point Symbol Access Point applet. A prompt
checkbox to enable the access