Table of Contents
Advertisement
4-30
AP-51xx Access Point Product Reference Guide
Add
SNMP Version
3. Configure the
the following:
Add
Delete
Destination IP
Port
Username
Security Level
Passwords
Add
Click
to create a new SNMP v1/v2c Trap Configuration entry.
Use the SNMP Version drop-down menu to specify v1 or v2.
Some SNMP clients support only SNMP v1 traps, while others
support SNMP v2 traps and possibly both, verify the correct traps
are in use with clients that support them.
SNMP v3 Trap Configuration
Click
Add
to create a new SNMP v3 Trap Configuration entry.
Select
Delete
to remove an entry for an SNMP v3 user.
numerical (non DNS name)
Specify a
receiving the traps sent by the
Specify a destination User Datagram Protocol (UDP) port for
receiving traps.
Enter a username specific to the SNMP-capable client receiving
the traps.
Use the
Security Level
level of noAuth (no authorization), AuthNoPriv (authorization
without privacy), or AuthPriv (authorization with privacy).
The "NoAuth" setting specifies no login authorization or encryption
for the user. The "AuthNoPriv" setting requires login authorization,
but no encryption. The "AuthPriv" setting requires login
authorization and uses the Data Encryption Standard (DES).
Select
Passwords
specifying authentication and password settings for an SNMP v3
user. The maximum password length is 11 characters. Use the
Authentication Algorithm
SHA1
as the authentication algorithm. Use the Privacy Algorithm
drop-down menu to define an algorithm of
If entering the same username on the SNMP Traps and SNMP
Access screens, the password entered on the SNMP Traps page
overwrites the password entered on the SNMP Access page. To
avoid this problem, enter the same password on both pages.
field (if SNMP v3 Traps are used) to modify
destination IP address for
access point
SNMP agent.
drop-down menu to specify a security
to display the
Password Settings
drop-down menu to specify
DES
screen for
MD5
or
or AES-128bit.
Advertisement
Table of Contents
