Symbol AP-51xx Product Reference Manual page 142

4-50 AP-51xx Access Point Product Reference Guide
7. Select FTP
8. Set the following FTP or TFTP parameters:
•Username
• Password
password is not supported.
NOTE Click
9. Click the
update, the AP reboots and completes the update.
NOTE The access point must complete the reboot process to successfully update
10. After the AP reboots, return to the Firmware Update screen. Check the
whether the firmware update was successful. If an error occurs, one of the following error
messages will display:
FAIL: auto fw update check
FAIL: network activity time out
FAIL: firmware check
FAIL: exceed memory limit
FAIL: authentication
FAIL: connection time out
FAIL: control channel error
FAIL: data channel error
FAIL: channel closed unexpected
FAIL: establish data channel
FAIL: accept data channel
FAIL: user interrupted
FAIL: no valid interface found
FAIL: conflict ip address
FAIL: command exchange time out
FAIL: invalid subnet number
or TFTP to define whether the firmware file resides on a FTP or TFTP server.
- Specify a username for the FTP server login.
- Specify a password for FTP server login. Default is symbol. A blank
Apply to save the settings before performing the firmware update.
The user is not able to navigate the access point user interface while the
firmware update is in process.
Perform Update button to initiate the update. Upon confirming the firmware
the device firmware, regardless of whether the reboot is conducted using
the GUI or CLI interfaces.
Status field to verify