Table of Contents
Advertisement
AP51xx>admin(system.snmp.access)> add
Description:
Adds SNMP access entries for specific v1v2 and v3 user definitions.
Syntax:
add acl
<ip1>
<ip2>
v1v2c
<comm> <access>
<oid>
v3
<user>
<access>
<auth>
<pass1>
For information on configuring SNMP access settings using the applet (GUI), see
Adds an entry to the SNMP access control list with <ip1> as the starting IP address and <ip2>
and as the ending IP address.
Adds an SNMP v1/v2c configuration with <comm> as the community (1-31 characters), the
read/write access set to
ro
(read only) or
string of 1-127 numbers separated by dot, such as 2.3.4.5.6).
<oid>
<sec>
<priv>
<pass2>
Adds an SNMP v3 user definition with the username <user> (1 to 31 characters), access set
to
ro
(read only) or
rw
(read/write), the object ID set to <oid> (1 to 127 chars in dot notation,
such as 1.3.6.1), the security type <sec> set to one of
The following parameters must be specified if <sec> is not none:
Authentication type <auth> set to
Authentication password <pass1> (8 to 31 chars)
The following parameters must be specified if <sec> is set to auth/priv:
Privacy algorithm set to
Privacy password <pass2> (8 to 31 chars)
rw
(read/write), and the Object Identifier <oid> (a
no
auth, authnopriv, or auth/priv.
md5
or
sha1
des
or
aes
Configuring SNMP Access Control on page
Command Line Interface Reference 8-161
4-26.
Advertisement
Table of Contents
