Table of Contents
Advertisement
Physical port status
change
DynDNS Update
Denial of service
(DOS) attempts
Send trap every
5. Configure the
System Traps
during transmission, saves its configuration file. When a trap is enabled, a trap is sent every
5 seconds until the condition no longer exists.
System Cold Start
Configuration
Changes
Rogue AP Detection
AP Radar Detection
WPA Counter
Measure
MU Hotspot Status
6. Click
Apply
to save any changes to the SNMP Traps screen. Navigating away from the
screen without clicking the Apply button results in all changes to the screen being lost.
7. Click
Undo Changes
settings displayed on SNMP Traps screen to the last saved configuration.
Generates a trap whenever the status changes on the access point.
The physical port status changes when a link is lost between the
access point and a connected device.
Generates a trap whenever domain name information is updated as
a result of the IP address associated with that domain being
modified.
Generates a trap whenever a Denial of Service (DOS) attack is
detected by the access point firewall. A new trap is sent at the
specified interval until the attack has stopped.
Defines the interval in seconds the access point uses to generate a
trap until the Denial of Service attack is stopped. Default is 10
seconds.
field to generate traps when the access point re-initializes
Generates a trap when the
transmitting, possibly altering the SNMP agent's configuration or
protocol entity implementation.
Generates a trap whenever changes to the
configuration file are saved.
Generates a trap if a Rogue AP is detected by the
Generates a trap if an AP is detected using a form of radar
detection.
Generates a trap if an attack is detected against the WPA Key
Exchange Mechanism.
Generates a trap when a change to the status of MU hotspot
member is detected.
(if necessary) to undo any changes made. Undo Changes reverts the
access point
re-initializes while
access point
access point
4-33
System Configuration
's
.
Advertisement
Table of Contents
