Use The Led Indicators; Table 4: Ucm6102/Ucm6104 Led Indicators; Table 5: Ucm6108/Ucm6116 Led Indicators - Grandstream Networks UCM6100 Series User Manual

•
•
•
Web Info
•
•
•
SSH Switch
By default, SSH access is disabled.

Use The LED Indicators

The UCM6100 has LED indicators in the front to display connection status. The following table shows the
status definitions.
LED Indicator
LAN
WAN
USB
SD
FXS (Phone/Fax)
FXO (Telco Line)
LED
NETWORK
ACT
USB
SD
Phone (FXS)
Line (FXO)
RTC Test Patterns
Select "2022-02-22 22:22" or "2011-01-11 11:11" to start the RTC (Real-
Time Clock) test pattern. Then check the system time from LCD idle screen
by pressing "DOWN" button, or from web GUISystem StatusGeneral
page. Reboot the device manually after the RTC test is done.
Hardware Testing
Select "Test SVIP" to perform SVIP test on the device. This is mainly for
factory testing purpose which verifies the hardware connection inside the
device. The diagnostic result will display in the LCD after the test is done.
Protocol: Web access protocol. HTTP or HTTPS. By default, it's HTTPS
Port: Web access port number. By default, it's 8089
Enable SSH: Enable SSH access.
Disable SSH: Disable SSH access.

Table 4: UCM6102/UCM6104 LED Indicators

LED Status

Table 5: UCM6108/UCM6116 LED Indicators

LED Status
UCM6100 Series User Manual
Solid: Connected
Flashing: Data Transferring
OFF: Not Connected
Solid: Connected
OFF: Not Connected
Solid: Connected
Flashing: Data Transferring
OFF: Not Connected
P a g e 44
|