Polycom SpectraLink 8020 Administration Manual page 99

PN: 1725-36038-001-L.doc
m m m m c h
m m m m c h
m m m m c h
m m m m c h
Where:
mmmm – This hexadecimal number is the last 2 octets of this AP's
•
MAC address
• ch – Channel number the AP is configured on
• -ss – Signal strength for the AP in dBm
• aid – The Association ID for the currently associated AP
AP mnem – a mnemonic indicating the reason code:
• Unkn – reason unknown
• Weak – signal strength too weak
• Rate – one or more basic rates not supported
Full – AP can not handle bandwidth requirements
•
AthT – authentication timeout
•
• AscT – association timeout
• AthF – authentication failure
• AscF – association failure
• SecT – security handshake timeout
• SecF – security handshake failure
• Cnfg – AP not configured correctly for security, QoS mode or
infrastructure network
CCX – AP is not CCX complaint.
•
• CCKM – AP does not support CCKM.
• WMM – AP does not meet the WMM requirements. Probable
reason could be that the access categories AC_VO and AC_VI,
used for voice and control traffic respectively, might not be
marked as mandatory or WMM-PS might not be enabled.
Screen 4
• Association count since power up (AssocCount)
- s s a i d
- s s m n e m
- s s m n e m
- s s m n e m
Diagnostic Tools
99