Polycom SpectraLink 8020 Administration Manual page 42

SpectraLink 8020/8030 Wireless Telephone: Administration Guide for SIP
42
Description
Configuration file
PHINTL (language translation)
USB downloader
Over-The-Air Downloader (OTADL)
OTADL Shim
Functional (telephony protocol)
See the next chapter for complete information on configuring the
handsets as described in steps 3 through 5 below.
3. Use the Handset Administration Tool to set up the
configuration of each handset to meet all essential
requirements. If not using the Handset Administration Tool,
ensure the following parameters are correctly set in the
menu for each handset: See the next chapter SpectraLink
8020/8030 Wireless Telephone Configuration for detailed
configuration instructions.
If statically assigning IP addresses, ensure that the
—
Subnet Mask , and
using a DHCP Server, ensure that the DHCP option is set.
Ensure the handset has properly configured
—
information.
Domain
Ensure the
Telephony Protocol
—
ensures the handset will check for the proper SIP files each
time it powers on.
Ensure security settings are properly programmed.
—
4. Configure handset security settings to match AP configuration
and RADIUS server settings. If WPA2-Enterprise security is
used, credentials will need to be installed onto the handset. For
EAP-FAST, the PAC file needs to be provisioned and for PEAP
the handset will need to be enrolled with a certificate (requires
use of the HAT). See the WPA2 Enterprise PEAP Certificate
Enrollment and EAP-FAST Manual PAC Provisioning section in
this guide for details.
5. Configure the QoS handset mode to match the AP and site QoS
plan. Follow the VIEW Configuration Guide for the appropriate
make/model of WLAN.
6. Power cycle the handset.
Default Gateway information are accurate. If
menu option is set to
Filename
slnk_cfg.cfg
pi1400sp.bin
pd14udsp.bin
pd14odsp.bin
pd14shim.bin
pd14csp.bin
Admin
Phone IP ,
SSID and Reg
. This
36
PN: 1725-36038-001-L.doc