Polycom SpectraLink 8020 Administration Manual page 55

PN: 1725-36038-001-L.doc
If you have an OAI Gateway installed in your system, OAI may be
optionally enabled in each handset. You may select whether the
handset should attempt to connect to the SpectraLink 8000 OAI
Gateway by choosing either the
menu.
If OAI is enabled, and an IP address (called the
available to the handset (either via DHCP or Static IP configuration),
the handset will communicate with the OAI Gateway at power-on,
and periodically while it is powered-on. If you don't have a
SpectraLink 8000 OAI Gateway installed at your site, you should
disable the OAI feature to preserve network bandwidth and battery
life.
Location Service
Location service may be used to enable or disable the Ekahau Real-
Time Location System (RTLS), select a transmit interval, or enter a
static IP address for the Ekahau Positioning Engine (EPE). Location
services capability is provided by the EPE 4.0 using Ekahau Location
Protocol (ELP). See Ekahau's user documentation for more
information.
RTLS [Enable/Disable]
to toggle to the alternate setting. When RTLS is enabled, the handset
will display the RTLS icon
The ring indicator icon will take precedence over the RTLS icon, i.e.
the new icon will not be visible while the handset is ringing. When
ringing has ceased and the ring indicator becomes inactive, the RTLS
icon will again appear (regardless of hook state).
Transmit interval Allows selection of
minute , 5 minutes , or 10 minutes
intervals. Default transmit interval is 10 minutes. Press
select the desired transmit interval.
To optimize battery life, the interval between sending out ELP
updates will vary based on handset state. It is expected that ELP
updates will occur at most every two to six seconds and at least
every few minutes. If improved tracking capability is desired, set the
transmit interval for a shorter time between ELP updates. Increasing
the frequency of transmissions will decrease battery life.
Location Server IP Allows the user to statically enter the IP address of
the EPE. Enter the IP address and press
Configure Each SpectraLink Wireless Telephone
Enable or Disable
The RTLS is disabled by default. Press
in the top center of the screen.
15 seconds
for maximum time between transmit
NavOK
options in this
OAI Server IP ) is
NavOK
, 30 seconds , 1
to
NavOK
to save.
55