Polycom SpectraLink 8020 Administration Manual page 137

Sample handset-specific file
# SIP Extension Specific Configuration file format example
# Maximum number of characters allowed per line (excluding comments) in this configuration file
is 121.
# /////////////////////////////////////////////////////////////////////////////////////////////#
# ////// Items IN THE PROXY SECTION should be in the sip_allusers.cfg file with
# ////// items uncommented in this file only for overriding a setting for a
# ////// particular user.
# /////////////////////////////////////////////////////////////////////////////////////////////#
# Codec preference order only.
# can be G.711-ulaw, g.711u, G.711U, g711u, G.711U, g729, G729, G.729, g729ab, g729AB
# if g711u is omitted it will be added to end of list.
# if g711a is omitted it will be added to end of list after u.
#CODECS = g711u, g711a
#-----------------------------------------------------------------------------------------------#
#
# PROXY settings... At least one is required and up to three may be specified.
# Where one is specicifed, all proxy settings must share the
# same numbered prefix (i.e. PROXY1_...)
#
# One PROXYn_TYPE (PBX/Call Server) entry is required, additional ones are optional as you
# can register secondary line appearances with other PROXY servers
# Uncomment Your Proxy Type from the list below
#
#PROXY1_TYPE
#PROXY1_TYPE
#PROXY1_TYPE
#PROXY1_TYPE
#PROXY1_TYPE
#PROXY1_TYPE
#PROXY1_TYPE
#PROXY1_TYPE
#PROXY1_TYPE
#PROXY1_TYPE
#PROXY1_TYPE
#-----------------------------------------------------------------------------------------------#
#-----------------------------------------------------------------------------------------------#
## FOR EACH PROXY TYPE LISTED ABOVE POLYCOM HAS FOUND THE FOLLOWING
## VALUES TO WORK WELL DURING TESTING, THOUGH YOUR SPECIFIC
## CONFIGURATION MAY VARY. UNCOMMENT OUT THE FIELDS PRECEEDED BY A
## SINGLE # TO ACCEPT THESE VALUES
## ADDITIONAL INFORMATION ABOUT EACH OF THESE FIELDS AS WELL AS SPECIFIC
## CONFIGURATION EXAMPLES CAN BE FOUND FURTHER DOWN IN THIS FILE
#-----------------------------------------------------------------------------------------------#
#-----------------------------------------------------------------------------------------------#
## FOR PROXY1_TYPE = NECSIP
#PROXY1_ADDR = 172.29.102.122:5060
Address
PN: 1725-36038-001-L.doc
This does not enable/disable codecs. (Optional)
= Asterisk
= NECSIP
= MITEL
= CCME
= PINGTEL
= ININ
= TOSHIBA
= CCM
= 3COM
= SHORETEL
= DELTAPATH
# replace the ip address with your Sip Server's
Sample SIP Configuration Files
137