Polycom SpectraLink 8020 Administration Manual page 101

PN: 1725-36038-001-L.doc
standard TLS alert message code. For example, if a bad/invalid
certificate (on the basis of its signature and/or content) is
presented by the server "xxx" will be 042. If the exact reason for
the certificate being invalid is not known, then the generic
certificate error code would be xxx=000. [Refer
http://www.ietf.org/rfc/rfc2246.txt
alert/error codes].
•
4xxx = Other TLS failures. This is due to TLS failure other than
certification related errors. The reason code (the TLS alert message
code) is represented by "xxx". For example, if the protocol version
presented by the server is not supported by the phone then xxx
will be 70, and the EAP error code would be 4070. [Refer
http://www.ietf.org/rfc/rfc2246.txt
alert/error codes].
•
5xxx = Security credential Failure. This is due to an invalid
username and/or password produced by the phone. xxx when
non-zero, presented the 3-digit error code sent by the server in
response to phone's credential. For example, if the server has sent
the error code as "691", then the EAP error code would be 5691. If
the server does not send the error code message, then xxx is
defaulted to 000, i.e., EAP error code would be 5000. Refer [1])
http://www.ietf.org/rfc/rfc2759.txt
http://ietfreport.isoc.org/all-ids/draft-zhou-emu-fast-gtc-02.txt
section 2.
E A P E r r C n t
L a s t E A P E r C o d e x x x x x
, section 7.2 for further TLS
, section 7.2 for further TLS
section 6, [2]
x x x x x
Diagnostic Tools
101