Polycom SpectraLink 8020 Administration Manual page 62

SpectraLink 8020/8030 Wireless Telephone: Administration Guide for SIP
62
selected in order for the handset to operate. There is no default
setting.
FCC requirements dictate that the menu for changing the regulatory
domain be available by password, which in our case is the
Press LINE and then navigate to the desired domain. Press
set the domain.
01 - North America
02 – Europe
03 – Japan
04 – Singapore
05 – Korea
06 – Taiwan
07 – Hong Kong
08 – Mexico, India
802.11 config
Once the regulatory domain is set, the
displayed. Only one may be chosen.
default. Press
NavOK
Subband list will open. If the mode does not have subbands, the
Transmit Powe r list will open.
g only
Use mode if all of your infrastructure and client devices will
use only 802.11g. The handsets will operate up to 54 Mb/s in this
mode. If any 802.11b capable clients or infrastructure are used in
your wireless LAN then do not use
802.11b and b/g mixed
b & b/g mixed
Use if some of your infrastructure components only
understand 802.11b. The handsets will operate up to 11 Mb/s.
Subbands have not been established for the
g only
the mode at this writing. Provisions are made in the software
to accommodate these ranges once established. Newly added
subbands may not appear in the
Subband
Once a mode is set the subband list will display, if applicable.
Only those ranges which are allowed in the set regulatory domain
and that pertain to the set mode are displayed. Note that for
802.11 Config
802.11(b & b/g mixed)
to set the mode. If the mode has subbands, the
g only
mode, instead use
mode for optimum performance.
Admin
menu table above.
LINE key.
NavOK to
modes are
is the
b and b/g mixed
or
PN: 1725-36038-001-L.doc