Polycom SpectraLink 8020 Administration Manual page 130

SpectraLink 8020/8030 Wireless Telephone: Administration Guide for SIP
#PROXY1_TYPE =TOSHIBA
#PROXY1_TYPE =CCM
#PROXY1_TYPE =3COM
#PROXY1_TYPE =SHORETEL
#PROXY1_TYPE =DELTAPATH
#-----------------------------------------------------------------------------------------#
#-----------------------------------------------------------------------------------------#
## FOR EACH PROXY TYPE LISTED ABOVE POLYCOM HAS FOUND THE FOLLOWING
## VALUES TO WORK WELL DURING TESTING, THOUGH YOUR SPECIFIC
## CONFIGURATION MAY VARY. UNCOMMENT OUT THE FIELDS PRECEEDED BY A
## SINGLE # TO ACCEPT THESE VALUES
## ADDITIONAL INFORMATION ABOUT EACH OF THESE FIELDS AS WELL AS SPECIFIC
## CONFIGURATION EXAMPLES CAN BE FOUND FURTHER DOWN IN THIS FILE
#-----------------------------------------------------------------------------------------#
#-----------------------------------------------------------------------------------------#
## FOR PROXY1_TYPE
#PROXY1_ADDR
# replace the ip address with your Sip Server's Address
#PROXY1_KEYPRESS_2833
#PROXY1_KEYPRESS_INFO
#PROXY1_HOLD_IP0
#PROXY1_PRACK
#PROXY1_REREG_SECS
#PROXY1_KEEPALIVE_SECS
#PROXY1_DOMAIN
# Replace this with your SIP Domain's name
#PROXY1_CALLID_PER_LINE = disable
#PROXY1_MAIL_ACCESS
# Put Your Voice Mail Sytem's Pilot Number here
#PROXY1_CONF_IP_ADDRESS = 172.29.102.131
## For each proxy of type NECSIP, one PROXYn_CONF_IP_ADDRESS is required
## This value is the address of NEC PBX's IP PAD card.
#-----------------------------------------------------------------------------------------#
## FOR PROXY1_TYPE
#PROXY1_ADDR
# replace the ip address with the Asterisk Server's Address
#PROXY1_KEYPRESS_2833
#PROXY1_KEYPRESS_INFO
#PROXY1_HOLD_IP0
#PROXY1_PRACK
#PROXY1_REREG_SECS
#PROXY1_KEEPALIVE_SECS
#PROXY1_DOMAIN
# Replace this with your SIP Domain's name
#PROXY1_CALLID_PER_LINE = disable
#PROXY1_MAIL_ACCESS
# Put Your Voice Mail Sytem's Pilot Number here
#-----------------------------------------------------------------------------------------#
## FOR PROXY1_TYPE
#PROXY1_ADDR
# replace the ip address with your PBX's Address
#PROXY1_KEYPRESS_2833
#PROXY1_KEYPRESS_INFO
130
= NECSIP
= 172.29.102.122:5060
= enable
= disable
= disable
= enable
= 3600
= 14
= necpolysip:5060
= 7999
= ASTERISK
= 172.29.65.6:5060
= enable
= disable
= disable
= enable
= 3600
= 14
= axlx.engr.local
= 7999
= MITEL
= 172.29.102.160:5060
= enable
= disable
PN: 1725-36038-001-L.doc