Producing Reports - Loma IQ2 User Manual

The batch is reset automatically whenever the product is changed or when a batch report is
generated.

Producing reports

The metal detector can produce a range of reports about product statistics, machine
calibration information, and machine status information. These can either be printed to a
printer attached to a unit or transmitted down the serial link to a PC or Network.
The reports are as follows:
Report
Error
Fault
Setup
Contaminants
Calibration
Status
PV test
Batch
7031
Description
Contains all the details from the Run Error log.
Contains all the details from the System fault log.
Contains the product Setup details from the Product setup and Manual
setup menus.
Contains all the details from the Contaminant log.
Contains all the data relevant to the calibration of the current product. This
report is printed automatically after a calibration cycle.
Contains the accumulated batch statistics since the start of the current
batch.
Contains all the data relevant to PV test operation.
This report contains all the batch statistics such as the number of rejects for
the current batch. This report is produced automatically on a batch-reset
command, a change of product, completion of the batch interval, or when
the unit is taken out of run. The batch interval can either be specified by time,
or if a photo-eye is fitted by number of packs.
51
Displaying and
printing reports