To set up a new product
V
• Press
to move to the next entry.
The display will show Full calibrate?
or Reverse calibrate? if the
Detection option is set to REVERSE
in the Product setup menu. For
information about reverse calibration
see Appendix A – Reverse
Calibration, page 138.
At this point you should have some
representative product ready to
calibrate and several samples should
be used.
e
• Press
to start the calibration
cycle and keep passing the product
until the calibration cycle is
complete.
The display will prompt you as
necessary.
When the calibration is complete the
unit will display Calibrate complete
and then return to the normal display.
Repeat the above set-up procedure with each of the products you wish to calibrate up to
100 in total.
7031
(Continued)
Full calibrate ?
+ Pass product +
Calibrating
+Calibrate complete+
Setting up a new
19
45
product