Related Manuals for Loma Superscan Micro ISC
Summary of Contents for Loma Superscan Micro ISC
- Page 1 A GUIDE TO COMMISSIONING SERVICE MENU MAP MACHINE DETAILS FOR: Machine Serial No: Line Number: LOMA Superscan Micro ISC...
- Page 2 A GUIDE TO COMMISSIONING LOMA Superscan Micro ISC...
-
Page 3: Commissioning Guide
When the detector is switched on for the first time it needs to be configured for the end application. Wherever possible this will be carried out by Loma before the unit is dispatched from our factory, or alternatively, by a LOMA Service Engineer during a commissioning visit. Primarily, this information is required to optimise machine performance for the application, and to enable certain features that the user may require. - Page 4 No Photo Eye Short 8 packs 20 seconds Long 20 packs 1 minute Extra Long 2 minutes Short is recommended for most applications, provided that at least eight packs can be passed during a calibration cycle. LOMA Superscan Micro ISC...
- Page 5 Set to YES or NO as required. YES will cause the fault relay to operate if a Performance Validation system test is not actioned or completed in the time allowed. Exit the User Options menu by pressing the [CANCEL] key once. LOMA Superscan Micro ISC...
- Page 6 CAL key once, followed by the [ ] key once and then the [ENTER] key once. • Now go back to the User Options menu and disable the access to product F (ACCESS FERR NO). The control unit is now fully commissioned for your application. LOMA Superscan Micro ISC...
- Page 7 On systems employing variable speed conveyors, special hardware is required to drive the CTB (conveyor time base) input on the micro control card. Conveyor systems supplied by LOMA will already have this hardware fitted and commissioned, but on head only sales the following information should be observed when using vari-speed.
- Page 8 A GUIDE TO COMMISSIONING LOMA Superscan Micro ISC...