Appendix B - Commissioning Guide - Loma IQ2 User Manual

140
Appendices
Appendix B – Commissioning Guide
Each time the detector is switched on the software version fitted on the detector's control
board will be displayed for approximately 0.5 seconds. If this is the first time the detector is
switched on it needs to be configured for the end application. Wherever possible this will be
carried out by Loma before the unit is dispatched, or by a Loma Service Engineer during a
commissioning visit. Primarily, this information is required to optimise machine performance
for the application, and to enable certain features.
There are circumstances, however, where it may be necessary for the end user to carry out
the commissioning procedure for the control unit himself. Typically, this would occur when
Loma do not have enough information about the end application, such as the belt speed or
reject details, to fully configure the machine. There are, in addition, other instances such as
performing a software update, moving the detector to a different application, replacing a
control card, etc. The unit can easily be set up from scratch as required. Alternatively, if only
small changes are required to the configuration of the machine, then the menu entries within
the Service menu can be adjusted individually.
Configuring the metal detector
Record the configuration details for the machine on the map menu. We suggest that you fill
this in when you configure the system, so that if you ever need to repeat the exercise all the
information will be ready to hand.
To enter the Configuration menu:
s
• Press .
V
until the display shows Service and press
• Press
V
until the password shows 76 and press
• Press
The display shows User options.
V
until the display shows Configuration and press
• Press the
The display shows +Not detecting+.
The correct parameters must now be entered into the configuration menu. For information
about using the menus see Using the menus, page 38.
e
.
e
.
e
.
11050