Loma IQ2 User Manual page 64

To adjust the sensitivity
• If necessary use C to move to the
top level of the menus.
• Select either the bargraph or
threshold/signal display.
• Press < or > to adjust the
sensitivity in the bargraph display.
• Press e.
• Press ^ or V to adjust the
threshold value in the threshold/signal
display.
• Press e to save the new value.
Higher thresholds give lower sensitivity
and lower ones higher sensitivity.
To change a product
• Press h.
• Press ^ or V to scroll through the
product selection to the desired
product.
• When the correct product is
displayed, press e to confirm your
selection.
To recalibrate a product
• Press c and then e to start the
process.
Keep passing product until the display
indicates that the calibration cycle is
complete.
May be obtained separately as part number 811261 issue level J 1/12/2003
7031
To set up a new product
• Press s.
• Press e twice.
• Use ^ or V to select the desired
product number.
• Press e to save the product number.
Scroll through the Product Setup list and adjust
the values as necessary. The Frequency option
will only appear if Dual frequency is set to YES
in the User options menu. The Flow length
option will only appear if a photo-eye is
connected to the system, in which case the
length to flow of the product should be entered.
The PV test setup will only appear if the
Performance Validation System is enabled, in
which case entries should be made in the menu
to program the system.
At the bottom of the list, when Full calibrate is
displayed, press e and pass product until the
display indicates that the calibration cycle is
complete.
To move around the menus
• To select a menu, press h (Change),
s (Setup), c (Calibrate), or r
(Results).
• To move between the options, use ^ or
V.
• Press e to move across the map to the
right.
• Press C to move across the map to the
left.
• To adjust a parameter shown on the
display, press e to change the ✱ to a < or
>, and then adjust the setting using ^ or
V.
• Press e to save a new setting.
47
Setting up a new
product