Loma IQ2 User Manual page 5

iv
Preface
7. LIFTING EQUIPMENT. Use only the correct slings and lifting tackle to move heavy items
of equipment described in this manual. Inspect all slings and lifting tackle prior to lifting
the equipment to ensure that:
(a) The safe working load will not be exceeded.
(b) There are no frayed or broken strands.
(c) Hooks, rings, etc. are not damaged.
8. MOVING METAL DETECTORS. The centre of gravity of some metal detectors is high.
Lower the height adjustment to its minimum before moving. Care must be taken when
moving such equipment on a slope to ensure that it does not topple over. This could
result in death or severe injury to an individual and/or severe damage to the metal
detector.
9. CONTAMINANTS. Oils and greases must always be handled with care. Prolonged bare
skin exposure to certain oils and greases can cause skin problems. Always handle oils
and greases in accordance with the manufacturer's instructions.
10.TRAPPED FINGERS. Do not place fingers on the underside of the conveyor when the
machine is operating. It is possible for fingers to be trapped and subsequently crushed
between a moving and fixed component of the machine.
11.OSHA. In the USA, the Occupational Safety and Health Administration (OSHA) Acts quite
clearly place the burden of compliance on the user of equipment, and the acts are
generalised to the extent that determination of adequacy of compliance is a judgement
decision on the part of the local inspector. Hence Loma cannot be held responsible for
meeting full requirements of OSHA or OHSA with regards to any equipment supplied, nor
can Loma be held liable for penalty which may be assessed for failure to meet the
requirements of the acts as interpreted by an authorised inspector. Loma, however, does
act in a responsible manner with regard to safe design of equipment and will always work
with customers to assist where possible in the remedy of any violations at a reasonable
cost to the buyer.
4028