Logs And Reports; Reports - Loma IQ3 User Manual

Logs and Reports

This chapter provides information about the available logs and reports that are generated from
information automatically collected by the IQ
To produce any report a
the report. Once a link has been established, any active report may be produced.

Reports

To set up the report options, proceed as follows:
Select Menus > Set Up > Report Options to display the Report Options menu options
1.
which are listed and described below.
Use the Scroll buttons
2.
to enable the value to be edited.
Use the Scroll buttons
3.
the Tick button
4. Repeat step 2 and 3 until you have selected and confirmed values for each option.
The Report Options menu provides the following options:
■
Form Feed
When this option is enabled a page break is included between each report being printed.
Options of YES (enabled) and NO (disabled) are provided for selection.
■
Carriage Return
When this option is enabled, each report is started at the beginning of the next new line.
Options of YES (enabled) and NO (disabled) are provided for selection.
■
All Reports
When this option is enabled, all available reports are made available for selection and sending
to the connected device, instead of having to scroll down the list and select them individually.
The individual reports options will therefore not be displayed for selection. Options of YES
(enabled) and NO (disabled) are provided for selection.
■
Reports
Menu options are a available for selecting the following Reports. Options of YES (enabled)
and NO (disabled) are provided for selection.
Errors Report
o
Faults Report
o
Setup Report
o
Contaminants Report
o
Learn Report
o
Status Report
o
PV Test Report
o
3
Metal Detector.
Serial Link must have been previously set up to match the device receiving
to confirm the selection.
to select each option in turn press the Tick button
to select the required option value and then press
107