Reports/Logs Package Upgrade - Loma IQ2 Service Manual

Main control
board

REPORTS/LOGS PACKAGE UPGRADE

The location of the reports/logs component is shown in
this section.
To enable the reports/logs option an additional component is required Loma part
number 411210. The device fits into a socket U4 located on the control board.
Before fitting the reports/logs option integrated circuit ensure the legs of the chip
are straight and correctly formed to ensure positive location into its base. Only
proprietary tools should be used to minimise the risk of damage. Failure to
observe this simple preparation may result in a poor insertion into the base. This
could result in permanent damage to the device and/or operational failure of the
detector.
Once fitted the menu positions associated with this device are automatically
enabled. Reference can now be made to your User Manual for information on
setting up the real time clock and the logs that are available. If it is intended to
use the reporting function or LomaLink then the additional serial link board and
associated cabling will be required.
Module 7026
Figure 15 Remote Sensor Board Location
Configuration and Set up Information
Sensor
board
l t
Fixing pillar
points
Figure 16
on page 33
h
JP3
JP4
in
5-32