Loma IQ2 User Manual page 161

144
Appendices
To set up serial links
If you are using any of the serial links, then you will need to set up the serial links as follows:
Serial link menu configuration
Link 1 may be set to one of the following options. Press
V
press it again and use
USAGE
LOMALINK For use with LomaLink control protocol.
or
REPORTS For use with LomaNet or a single printer.
e
• Press to accept.
When LOMALINK or REPORTS is selected further menu entries within the link allow the
protocol to be set.
V
• Press to step down the menu below:
Baud rate
Data bits
Stop bits
Parity
Flow Ctrl
e
• Pressing in any menu position changes the "*" to a ">". Use
entry required then press
C
• Pressing will exit the menu without making any changes.
NOTE: Please refer to Displaying and printing reports, page 49, if using the report option, or
appropriate LomaView, LomaNet or LomaLink information.
The machine will now be looking for metal in your product, although the sensitivity will not be
fully optimised as the detector has not yet been calibrated for the product. Before any
products can be calibrated, it will be necessary to perform a ferrite tune in order to minimise
the effects of vibration when running products with no product effect.
to select one of the uses below:
NOT USED is the default setting.
For use with LomaView management systems.
150, 300, 600, 1200, 2400, 4800, 9600
7 or 8
1, 1.5 OR 2
ODD, EVEN or NO
NONE, CTS-RTS or XON-XOFF
e
again to accept.
e
to select the usage list then
^ V
or to select
11050